Posts: 1,501
Threads: 132
Likes Received:
98 in 92 posts
Likes Given: 27
Joined: May 2020
Reputation:
99
Points: 26,492.38
Achievements:
(View All Achievements)
Rank:
I have a retaining wall that could use some finishing touches. I've specifically avoided putting caps on it because the wall itself has a changing curvature over about a 15-foot span, and so each cap would have to be custom cut. Short of renting a masonry saw, how big of a PITA is it to make straight cuts in 3-5 inch cap blocks?
Are the masonry blades for a circular saw worth anything? Is it easier just to score them and then hit with a chisel to split?
I'll post pics when it's all done, but this is really the last major bit of the back deck project, and after 2 years, I'm itching to get it finished off.
Posts: 4
Threads: 0
Likes Received:
0 in 0 posts
Likes Given: 1
Joined: May 2020
Reputation:
0
Points: 46.84
I used a masonry blade on the circular saw. For the paver brick work I plan on a combination of the circular saw again and a masonry blade on the angle grinder. Oh, and beer
Posts: 1,501
Threads: 132
Likes Received:
98 in 92 posts
Likes Given: 27
Joined: May 2020
Reputation:
99
Points: 26,492.38
Achievements:
(View All Achievements)
Rank:
Scoring about 3/16 deep and whacking with a BFH and chisel seemed to give me the split face effect I was after while keeping a straight line at the break. I just used the circ saw. As I was buying the masonry blade it did occur up me that the angle grinder probably would have accomplished the same thing. I never think if that out of the context of metal.
Posts: 1,501
Threads: 132
Likes Received:
98 in 92 posts
Likes Given: 27
Joined: May 2020
Reputation:
99
Points: 26,492.38
Achievements:
(View All Achievements)
Rank:
Probably. I was just going straight, though.
Posts: 985
Threads: 60
Likes Received:
76 in 60 posts
Likes Given: 190
Joined: Apr 2020
Reputation:
65
Points: 33,444.76
Achievements:
(View All Achievements)
Rank:
Ah. Then circular saw away!